HP StorageWorks B-series Data Center Fabric Manager Professional 10.1.x Release Notes (5697-0804 July 2009 - includes all 10.1.x versions)

SolutionClosed defect summary
Fixed in DCFM 10.1.0References to IOD Delay dialog are found in several
places in online help.
Symptom—References to IOD Delay configuration
dialog are found in several places in the online help
even though this dialog does not exist in the
application.
Fixed in DCFM 10.1.0Help for Event Notification needs to be modified (both
in the online help and PDF document).
Symptom—User will get incorrect information
regarding the Event Notification feature from online
help and the PDF document.
Fixed in DCFM 10.1.0
Workaround—The user must rely on the Master log
for all the lost events.
On closing and re-launching the Audit logs table in
DCFM, some of the events that were present disap-
pear.
Symptom—When the customer close and relaunches
the Audit logs table, some of the events that were
present earlier will not appear.
Fixed in DCFM 10.1.0The online help for Call Home needs to be modified.
Symptom—User will get wrong information regarding
Call Home.
Fixed in DCFM 10.1.0
Workaround—Manually delete all the LSAN zones
from the fabric through EOS.
Deleting LSAN zones from the LSAN zoning scope
does not work for a fabric that is in the “McDATA
Open Fabric Mode”.
Symptom—The customer see an error message which
says "Unable to activate the zones in the McDATA
Open Fabric Mode". As a result, the customer will not
be able to delete the LSAN zones from the fabric.
Fixed in DCFM 10.1.0Online help for Set End to End Monitor dialog does
not mention the Refresh button in the dialog.
Symptom—The user does not get any information in
the online help content regarding the Refresh button
in the Set End To End monitors dialog.
Fixed in DCFM 10.1.0
Workaround—Delete the tunnel again from Switch
properties where the tunnel is created.
If a user deletes all the tunnels and creates new
nl
tunnels, the older tunnel is shown in the switch
nl
properties of DCFM.
Symptom—Customer can see the older tunnel shown
in the FCIP tunnels tab of switch properties. If the user
needs to check the FCIP tunnel ID drop-down, that
tunnel is not shown.
Fixed in DCFM 10.1.0The Call Home section in the PDF document needs to
be modified.
Symptom—The user will not get proper information
from the PDF document.
HP StorageWorks B-series Data Center Fabric Manager Professional 21