HP StorageWorks Fabric OS 6.3.3d Release Notes (5697-0493, May 2010 - includes all 6.3.0x versions)

Fixed in Fabric OS 6.3.0
Workaround prior to code change:
The following should work. Following
any removal or relocation of an
encryption blade from any chassis
slot, do an hafailover to cause the
standby CP to become active. This
should be done even if no change in
chassis IP addresses is required as
other problems could be otherwise
encountered, depending on network
configuration.
Ipaddrset command to set Lance GE ports IP address is non-respons-
ive. Must reboot active CP to activate IP.
Fixed in Fabric OS 6.3.0
Optimized SERDES setting for Brocade 8 Gb SAN Switch for
BladeSystem c-Class.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
No workaround needed, the DC SAN
Director CP fails over non-disruptively
and retains all configuration data.
If TI zone operations are performed simultaneously on different
switches, active CP may failover due to termination of Name server
module.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Lock the port to fixed speed.
4 Gb switch running at fixed 2 Gb speed may not respond to FLOGI
from HBA using auto-speed negotiation.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Wait for system to stabilize after
executing bladedisable and
before issuing hafailover or
disable MS platform services while
performing stress testing.
Detected termination of management server daemon during stress
testing on DC SAN Director with 8 logical switches.
Fixed in Fabric OS 6.3.0
FOS-FVT- If a Read is Sent Busy Status and the Subsequent Seek is also
Sent Busy, Mis-Compares To the Host.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Do the following to back up licenses:
1. Execute licenseshow command
save the licenses into a file outside the
switch. 2. Then perform
configdownload. 3. Add the
licenses saved in step one.
Downloading config file between switches causes license lost.
Fixed in Fabric OS 6.3.0
Inconsistent display of urouteshow trying to map to invalid FCR user
port while topologyshow is not showing those routes.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Specify LF role list in the RADIUS
server for the account.
If user account on RADIUS server is set up with only Chassis level role
as primary, but it is not on the LF role list, the user cannot login.
Fixed in Fabric OS 6.3.0
Missing Pause and Resume for EX port having MiI10K Edge Fabric in
239 Domain - works for domain 209-238.
HP StorageWorks Fabric OS 6.3.0d Release Notes 63