HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

SAN Director installation guide 145
For FC4-16IP supported configurations, see the HP StorageWorks SAN design reference guide:
http://h18000.www1.hp.com/products/storageworks/san/documentation.htm
l
Items included with the FC4-16IP Blade
The following items are included in the shipping carton:
• B-Series iSCSI Director Blade
• One accessory kit
Optional items
Purchase the following items separately (as needed):
• Small-form-Factor Pluggable SFP transceivers
• SFP transceivers for the GbE ports
Installing the FC4-16IP Blade
Complete the following tasks to install the FC4-16IP:
1. ”Verifying 4/256 SAN Director prerequisites” on page 145
2. ”Installing the FC4-16IP Blade into the 4/256 SAN Director” on page 145
3. ”Cabling the FC4-16IP Blade” on page 146
Verifying 4/256 SAN Director prerequisites
To verify the 4/256 SAN Director prerequisites:
1. Log into the 4/256 SAN Director as admin.
2. Enter the chassisConfig command, and verify that it is in mode 5. If the chassisConfig
mode is 5, this step is complete. If not, enter the chassisConfig 5 command. Changing the
chassisConfig mode requires a reboot, and is disruptive to switch operation.
3. Enter the firmwareShow command, and verify that the firmware level on both CPs is Fabric OS
5.2.
1b or higher. If not, use the firmwareDownload command to install the proper Fabric OS
level before installing the FC4-16IP blade.
4. Verify that the 4/256 SAN Director has four power supplies installed prior to installing the
FC4-16IP blade.
Installing the FC4-16IP Blade into the 4/256 SAN Director
To install the FC4-16IP blade:
1. Select an empty slot in the 4/256 SAN Director.
2. Make sure the latches on the FC4-16IP blade are unscrewed and open.
3. Slide the FC4-16IP blade into the open slot.
4. Close and screw the latches and power on the blade using the power switch at the top of the
blade. The FC4-16IP blade starts POST. After POST completes, the firmware version on the blade