HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

SAN Director installation guide 165
9. Record the cable connections between the 4/256 SAN Director and the target device and ports
(see Table 42).
NOTE: Copying the individual switch configurations, miscellaneous configuration information,
SAN profile, and supportShow output into text files is recommended. Recommended file names
are “config-switch.txt,” “config-miscinfo.txt,” “SANbefor.txt,”and “spptshow.txt,” respectively.
Table 42 Critical information checklist
Configuration information
Location of “config-switch.txt” file:
Location of “config-miscinfo.txt” file:
IP address, subnet mask:
WWN for Director:
SAN profile
Location of “SANbefor.txt” file:
Notes regarding nsshow output:
Notes regarding nsallshow output:
Notes regarding switchshow output:
Notes regarding fabricshow output:
Output from supportshow command
Location of “spptshow.txt” file:
Notes regarding supportshow output:
Information About the New Chassis
New Factory Serial Num:
New Serial Num (if available):