HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

Replacing the chassis170
Configure new chassis serial number
Use these steps to configure a new chassis serial number.
1. Open a CLI session (telnet or serial) and log in as root. The root and factory account disclaimer
displays:
2. Change the Factory Serial Number to the serial number of the new chassis (the serial number is
provided on the barcode sticker on the port side of the new chassis):
a. Type fruInfoSet chassis 1 at the prompt.
b. Type the OEM serial number, if any, at the “SN” prompt.
c. Type the chassis serial number at the “Chassis SN:” prompt.
Fabric OS (swDir)
login: root
Password:
Disclaimer for Root and Factory Accounts Usage!
This Fibre Channel switch is equipped with Root and Factory accounts
that are intended for diagnostics and debugging purposes solely by
the Equipment vendor's trained engineers. Improper use of the
functionality made available through the Root or Factory account could
cause significant harm and disruption to the operation of the SAN fabric.
Your use of the functionality made available through the Root or Factory
account is at your sole risk and you assume all liability resulting from
such use. The Equipment vendor shall have no liability for any losses
or damages arising from or relating to the use of the Root or Factory
account (and the functionality enabled thereby) by anyone other than
the Equipment vendor's authorized engineers.
Proceeding with the usage of this switch as the Root or Factory user
explicitly indicates your agreement to the terms of this disclaimer.
swDir:root>