HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

Installing and configuring the 4/256 SAN Director40

Installing the switch as a stand-alone unit

The following items are required:

• 4/256 SAN Director

• AC power cords and cables supplied with the switch

Removing the chassis door

CAUTION: You must remove the chassis door before lifting the chassis off the pallet.

See Figure 5 for an illustration of the complete chassis door removal sequence.

1. Open the door to a 90° angle.

2. Push the spring-loaded lever on the upper hinge up and into the notch in the hinge.

3. Push the spring-loaded lever on the lower hinge down and into the notch in the hinge, while

supporting the door to prevent it from falling.

Figure 5 Sequence for detaching the chassis door from the hinges

NOTE: Put the chassis door aside. You will need to reinstall it after moving the switch off the pallet.

4. Position the pallet so that the bottom of the chassis is level with the installation surface.

1 2 3

SHR-2508