HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

SAN Director installation guide 51
4. Use the lift device to raise the chassis until the bottom of the chassis is level with the shelf-like
surfaces of the rack mount shelf brackets.
5. Slide the chassis onto the two rack mount shelf brackets.
Securing the chassis to the rails
1. Attach the two flat upper rack mount brackets (that you installed on the chassis earlier) to the two
L-shaped brackets installed onto the rack rails. Use the two screws set aside in step 1 of
”Attaching the upper rack mount bracket assemblies to the chassis” on page 48. See Figure 10.
Figure 10 Attaching the upper rack mount bracket to the L-shaped brackets
2. Tighten screws, and torque to 32 inch-pounds.
SHR-2513A