HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

SAN Director installation guide 53
Powering on the 4/256 SAN Director
NOTE: If using a modem with the 4/256 SAN Director, it needs to be connected prior to powering
on the switch. To install a modem, refer to Setting up and installing modems, page 155.
To provide power to the 4/256 SAN Director:
1. Verify that the ON/OFF switch for each port blade and CP card are in the ON position.
2. Verify that the AC switch covers are installed over the AC switches. These clear plastic covers fit
over the AC switches with their edges tucked underneath the outlet covers; they prevent the AC
switches from being powered on or off accidentally (see Figure 12).
3. Connect the AC power cord retainers to the chassis: orient a retainer against the AC panel as
shown in Figure 12, place the retainer tabs under the two jack screws on either side of the power
receptacle, and tighten the screws. Repeat for the other retainer (note that the power cord
retainers are oriented in the same direction as the power receptacles).