HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

Installing and configuring the 4/256 SAN Director56
5. Open the terminal emulator application and configure as follows:
For most MS Windows systems:
•Bits per second:9600
•Databits:8
•Parity:None
•Stop bits:1
•Flow control:None
For most UNIX systems, type the following string at the prompt:
tip /dev/ttyb -9600
When the terminal emulator application stops reporting information, press Enter. You will
receive the following login prompt:
CP0 Console Login:
6. Log in to the 4/256 SAN Director as admin. The default password is “password”. At the initial
login, the user is prompted to enter new admin and user passwords. Make sure to write down
the passwords and keep this information in a secure location.
7. (Optional) Modify passwords, if desired. Passwords can be 8 to 40 characters long. They must
begin with an alphabetic character. They can include numeric characters, the dot (.), and the
underscore (_). Passwords are case-sensitive, and they are not displayed when you enter them
on the command line.
To skip modifying the password, press Ctrl-C. For more information on
passwords, refer to the HP StorageWorks Fabric OS administrator guide.
8. Check the “Active CP” LED on the CP cards in slots 5 and 6, or type haShow to verify which CP
card is active.
The configuration can be modified only through a login session to the active CP card.
swDir:admin> hashow
Local CP (Slot 6, CP1): Active
Remote CP (Slot 5, CP0): Standby, Healthy
HA enabled, Heartbeat Up, HA State synchronized