HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

SAN Director installation guide 63
Follow these steps to configure the IP addresses for both CP cards (from the active CP card):
1. Login to the active CP as admin using the Serial Cable connection.
2. Set up the Director IP address by entering the ipaddrset -sw 0 command:
Enter the requested information at the prompts.
TIP: Unlike the Core Switch 2/64 or SAN Director 2/128, the only valid configuration for the
4/256 SAN Director is as a single domain (single logical switch), so you only need to specify the
-sw 0 IP address. There is no -sw 1 in the 4/256 SAN Director.
3. Set up the CP0 IP address by entering the ipaddrset -cp 0 command:
Enter the requested information at the prompts.
4. Set up the CP1 IP address by entering the ipaddrset -cp 1 command:
Enter the requested information at the prompts.
swDir:admin> ipAddrSet -sw 0
swDir:admin> ipAddrSet -cp 0
swDir:admin> ipAddrSet -cp 1