HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

SAN Director installation guide 69
3 Monitoring system components
This chapter provides information about determining the status of the following components via LEDs
and CLI commands.
• Port blades, page 69
• CP card, page 80
• Power supplies, page 83
• Blower assemblies, page 86
• WWN card, page 88
You can also set up monitoring alerts using SNMP, syslog, or license-enabled software features
(such as Fabric Watch, Advanced Web Tools, and Performance Monitoring).
Port blades
Use these steps to determine port blade status.
1. Check the LED indicators on the port blade. The LED patterns may temporarily change during
POST and other diagnostic tests; for information about how to interpret the LED patterns, refer to
Table 15 on page 78.
2. Type slotShow to check the port blade status.
• Figure 15 shows FC4-16 port blade components and LEDs.
• Figure 16 shows FC4-32 port blade components and LEDs.
• Figure 17 show FR4-18i port blade LEDs
• Figure 18 shows FC4-48 port blade components and LEDs.
• Figure 19 shows FC4-16IP port blade components and LEDs.