HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

Installing FRUs94
Chassis door summary
WARNING! The chassis door is required to ensure that these devices meet Electro Magnetic
Interference (EMI) and regulatory certifications.
The 4/256 SAN Director integrates a shorter chassis door in comparison to earlier SAN Director
models.
Reinstalling the chassis door
The replacement procedure for the chassis door takes less than five minutes. See Removing the
chassis door, page 40 for chassis door removal procedures. Use these steps to replace a chassis
door.
1. Make sure that the levers on the spring-loaded pins on both hinges are pushed into the notches.
2. Align the spring-loaded pins with the chassis portion of the hinges.
3. Release the pins by pushing the levers out of the notches.
CAUTION: To avoid damaging the chassis and door, do not open the door more than 90 degrees.
Figure 24 Upper door hinge
25034a