HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

SAN Director installation guide 95
Cable management comb and pillars summary
This section provides instructions for replacing a cable management comb.
The cable management comb included with the 4/256 SAN Director is designed to accommodate
multiple cables. Figure 25 and Table 26 identify the cable management comb components.
Figure 25 Cable management comb
Cable pillars can be used to group cables for Directors.
The replacement procedure for the cable management comb or pillar takes less than five minutes.
The following items are required for the cable management comb replacement procedure:
• Cable management comb
• #2 Phillips screwdriver
CAUTION: Do not use a power screwdriver to install the cable management comb.
Table 26 Cable management comb components
Number Description
1 Ground strap connector
2 Captive screws (2 per cable management
comb)
POWER SUPPL
Y 1 & 3
POWER SUPPL
Y 2 & 4
1
25032a
2