Brocade Fabric OS Documentation Updates - Supporting Fabric OS v6.4.x (53-1002063-09, August 2012)

Fabric OS Documentation Updates 21

53-1002063-09

perfShowEEMonitor

Displays end-to-end performance monitor information on a port.

Synopsis perfcshoweermonitor [slotnumber/]portnumber [interval]

Description Use this command to display end-to-end monitor information on a port. Refer to perfMonitorShow

for details regarding this command’s output. Output displays may vary depending on platform.

Notes This command requires a Brocade Advanced Performance Monitoring license.

This command is not supported on virtual FC ports (VE/VEX_Port), EX_Port, M (Mirror) ports and

GbE ports.

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command

Availability" for details.

Operands This command has the following operands:

slotnumber For bladed systems only, this operand specifies the slot number of the port

on which the monitor is to be displayed, followed by a slash (/).

portnumber Specifies the number of the port on which the monitor is to be displayed,

relative to its slot for bladed systems. Use switchShow for a list of valid ports.

interval Specify an interval, in seconds (5 or more). Tx and Rx counts are in the unit of

bytes when this operand is specified. This operand is optional; if omitted, this

command displays cumulative counts.

Examples To display EE monitors configured on the switch port 0:

switch:admin> perfshoweemonitor 0

There is 1 end-to-end monitor(s) defined on port 0.

KEY SID DID OWNER_APP TX_COUNT

-----------------------------------------------------

0 0x112233 0x223344 TELNET 0x00000000000

RX_COUNT CRC_COUNT OWNER_IP_ADDR

------------------------------------------------------

0x0000000000000000 0x0000000000000000 N/A

The output displays the key, source and destination PID, client application used to add the monitor,

client IP address where application is running followed by different counters. CLI shows IPv6

address for OWNER_IP_ADDR field. If the monitor is added using perf CLIs OWNER_IP_ADDR field

will display as N/A. When a monitor is created using a telnet application, the IP address continues

to display as N/A.

To display the EE monitor configured on the switch port 0 using an application that passes an IPV6

address:

switch:admin> perfshoweemonitor 0

There is 1 end-to-end monitor(s) defined on port 0.

switch:admin> perfshoweemonitor 0

KEY SID DID OWNER_APP TX_COUNT

-----------------------------------------------------

18 Fabric OS Documentation Updates

53-1002063-06