Brocade Fabric OS Documentation Updates - Supporting Fabric OS v6.4.x (53-1002063-09, August 2012)

48 Fabric OS Documentation Updates
53-1002063-09
Documentation updates for Fabric OS v6.4.0 and later
7
Chapter 2, Fabric Watch Thresholds
On page 15 and 16, the sections “High and low thresholds” have been changed to include the
following expanded threshold categories:
• Above high threshold
• Below high threshold
• Above low threshold
• Below low threshold
NOTE
The above low threshold action applies only to the portThConfig command. It does not apply to the
thConfig and sysMonitor commands.
In-between buffer values
The below high threshold is the term used to configure “in between” buffer values, as shown below.
In this example, the high threshold value is 5 and the buffer value is 1. Therefore, the “in-between”
boundary value is 4. Enter the portThConfig command using the following parameters.
portthconfig --set port -area crc -highth -value 4 -trigger below -action raslog
Above high threshold
Above action = 5
_______________________________________________________________________________
BUFFER = 1
_______________________________________________________________________________
Low action
Below high threshold
In-between
Above low threshold
Above action
______________________________________________________________________________
BUFFER
______________________________________________________________________________
Low action
Below low threshold
Chapter 4, Fabric Watch Activation
On page 30 “snmpConfig -set” should appear as “snmpConfig --set”.