DCFM Enterprise User Manual (53-1001775-01, June 2010)

DCFM Enterprise User Manual 271
53-1001775-01
Editing an Port offline policy
10
Editing an Port offline policy
To edit an Port offline policy, complete the following steps.
1. Select Monitor > Event Policies.
The Event Policies dialog box displays.
2. Select the policy you want to edit in the Policies table.
3. Click Edit.
The Edit Event Policy dialog box displays.
4. Edit the trigger in the IP Address, Node WWN, and Name list.
The trigger is limited to 1024 characters. Multiple values must be separated by a semi-colon.
When multiple values are entered, as long as at least one value matches the IP address, Node
WWN, or Name in the event and all other conditions are met, an action is triggered.
IP addresses can either be in IPv4 or IPv6 format and must be complete.
A Node WWN is accepted with or without the colon.
5. Change the count value (between 2 and 999) in the Count field.
6. Change the duration value (between 1 and 999) in the Duration field.
7. Select the duration type (Seconds or Minutes) from the Duration list.
The maximum duration is 30 minutes.
8. Select the check box in the Actions list for each action you want to occur when this policy is
triggered.
For a list of the available actions, refer to “Policy actions” on page 258. To define an action,
refer to “Defining the broadcast message action” on page 262, “Defining the launch script
action” on page 263, “Defining the send e-mail action” on page 264, or “Configuring support
data capture action” on page 265.
9. Click OK on the Edit Event Policy dialog box.
10. Select the Active check box to activate the policy.
11. Click OK on the Event Policies dialog box.