DCFM Enterprise User Manual (53-1001775-01, June 2010)

422 DCFM Enterprise User Manual
53-1001775-01
Minimum CEE configuration for FCoE traffic
17
Minimum CEE configuration for FCoE traffic
You must complete the following procedures to create the basic configuration of CEE for FCoE
traffic.
NOTE
The first two procedures in this section can be completed as a single procedure. They were broken
into two separate procedures for clarity.
Creating a CEE map to carry the LAN and SAN traffic
To create a CEE map to carry the LAN and SAN traffic, complete the following steps.
1. Select Configure > Switch > CEE.
The CEE Configuration dialog box displays.
2. Select the switch to edit in the CEE Ports and LAGs table and click Edit.
The CEE Edit Switch dialog box displays.
3. Click the QOS tab.
The CEE Edit Switch - QoS tab dialog box displays
FIGURE 173 CEE Edit Switch dialog box - QOS tab
4. Use “Creating a CEE map” on page 438 to create a new CEE Map to carry the traffic types, as
shown in the dialog box above.
5. Click Close on the CEE Configuration dialog box.