DCFM Enterprise User Manual (53-1001775-01, June 2010)

DCFM Enterprise User Manual 551

53-1001775-01

Configuring hosts for encryption targets

Use the Encryption Target Hosts dialog box to edit (add or remove) hosts for an encrypted target.

NOTE

Hosts are normally selected as part of the Configure Storage Encryption wizard but you can also edit

hosts later using the Encryption Target Hosts dialog box.

1. Select Configure > Encryption from the menu bar.

The Encryption Center dialog box displays.

2. Select the encryption group, switch, or encryption engine containing the storage device to be

configured.Right-click, or select Group, Switch, or Engine from the menu bar.

3. Select Targets.

The Encryption Targets dialog box displays.

4. Select a Target storage device from the list, and click Hosts.

The Encryption Target Hosts dialog box displays. This dialog box lists configured hosts in a

fabric.

5. Select one or more hosts in a fabric and move them to the Selected Hosts table.

FIGURE 244 Encryption Target Hosts dialog box