DCFM Enterprise User Manual (53-1001775-01, June 2010)

ManualsBrandsHP ManualsStorageHP 8/80 Base (48) Full Fabric Ports Enabled SAN Switch

671

672

673

674

675

676

677

678

679

680

DCFM Enterprise User Manual 633

53-1001775-01

Traffic isolation zoning

• 8 Gbps 16-FC ports, 6-Gbit ports Extension Switch

• 24 - 8 Gbps FC Port, 8 - 10 Gbps CEE Port Switch

• 8 Gbps 40-port Switch

• 384-port Backbone Chassis

• 192-port Backbone Chassis

• 8 Gbps Encryption Switch

Enhanced TI zones are supported only if the following conditions are met:

• Every switch must be one of the supported platforms, as listed above.

• Every switch must be running Fabric OS v6.4.0 or later.

If the fabric contains a switch running an earlier version of Fabric OS, you cannot create an

enhanced TI zone.

The failover mode must be the same for each enhanced TI zone to which a port belongs.

You cannot merge a downlevel switch into a fabric containing enhanced TI zones, and you cannot

merge a switch with enhanced TI zones defined into a fabric containing switches that do not

support ETIZ.

NOTE

FC router domains and EOS switches are excluded from the ETIZ platform restrictions. You can

create enhanced TI zones with these switches in the fabric.

Configuring traffic isolation zoning

The following procedure provides an overview of the steps you must perform to configure traffic

isolation zoning.

Note that for any zoning-related procedure, changes to a zone database are not saved until you

click OK or Apply on the Zoning dialog box. If you click Cancel or the close button (X), no changes

are saved.

1. Select Configure > Zoning > Fabric.

The Zoning dialog box displays.

2. Click the Zone DB tab if that tab is not automatically displayed.

3. Select an FC fabric from the Zoning Scope list.

This identifies the target entity for all subsequent zoning actions and displays the zoning

database for the selected entity.

4. Select Domain, Port Index from the Type list.

5. If you want to show all discovered fabrics in the Potential Members list, right-click in the

Potential Members list and select Display All.

6. Create the traffic isolation zones.

For specific instructions, refer to “Creating a traffic isolation zone” on page 634.