DCFM Installation, Migration, and Transition Guide - Supporting DCFM 10.3.x (53-1001360-01, October 2009)

DCFM Installation, Migration, and Transition Guide 181
53-1001360-01
Enterprise edition pre-migration requirements on UNIX systems
2
18. Verify your configuration and license information on the Server License Summary screen and
click Next.
19. Select the Start Client check box, if necessary, on the Start Server screen and click Finish.
After all of the DCFM services are started, the Log In dialog box displays.
20. Enter your user name and password.
The defaults are Administrator and password, respectively. If you migrated from a previous
release, your username and password do not change.
21. Click Login.
22. Click OK on the Login Banner.
Enterprise edition pre-migration requirements on UNIX systems
Before you migrate from Enterprise edition, complete the following:
• Make sure that you fully back up your current Management application data on your
management server.
• Make sure you close all instances of the application before upgrading.
• Check for and install the latest Java patches for your operating system. DCFM requires
JRE 1.6.0. For the Solaris web site listing patch information, go to
http://java.sun.com/javase/downloads/index.jsp.
• (Solaris only) To use IPv6 on a server that is IPv4- and IPv6-enabled, complete the following
steps.
a. Open a command window.
b. Type
ifconfig <interface name> inet6 plumb up and press Enter.
c. Restart the Management server and client, if running.
If the IPv6 address is not configured properly, the client will show a "Server Not Available at
port 24600" message even though the server started successfully.
• Make sure that an X Server is available for display and is configured to permit X Client
applications to display from the host on which they are installing the DCFM Server (typically,
this simply requires that the systems console be present and running with a logged in user on
the X Server-based desktop session, such as KDE, GNOME, and so on).
• Make sure that the DISPLAY environment variable is correctly defined in the shell with a valid
value (for example, to display to the local console, export DISPLAY=:0.0, or to display to a
remote system that has an X Server running, export DISPLAY=remoteipaddress:0.0).
You may also need to consider a firewall that might block the display to the X Server which
listens by default on TCP port 6000 on the remote host.
To display to a remote system you need to permit the remote display of the X Server by running
command xhost +IP, where IP is the IP address of the DCFM server host from the X-based
desktop of the remote system.
• Make sure you test the DISPLAY definition by running the command xterm from the same shell
from which you run install.bin. A new X terminal window to the destination X Server display
should open.