DCFM Installation, Migration, and Transition Guide - Supporting DCFM 10.3.x (53-1001360-01, October 2009)

214 DCFM Installation, Migration, and Transition Guide
53-1001360-01
Post migration requirements on Windows systems
2
19. Verify your configuration and license information on the Server License Summary screen and
click Next.
20. Click Start on the Apply User Settings screen.
User Settings migration may take up to 30 minutes.
21. Click Next on the Apply User Settings screen.
22. Select the Start Client check box, if necessary, on the Start Server screen and click Finish.
After all of the DCFM services are started, the Log In dialog box displays.
23. Enter your user name and password (as configured in FM).
24. Click Login.
25. Click OK on the Login Banner.
Post migration requirements on Windows systems
• Check existing fabrics to make sure they are still displayed correctly.
• Discover a new fabric to make sure it populates the GUI correctly.
• Perform zoning on a fabric from DCFM to make sure that the fabric is reachable.
Pre-migration requirements on UNIX systems
Before you migrate from Fabric Manager, complete the following:
• Make sure that a version of Fabric Manager is installed on your server that meets migration
requirements. For information about upgrading to a version of Fabric Manager that meets
migration requirements, refer to the Upgrade Instructions for Fabric Manager. You may also
need to upgrade FOS versions on supported switches and directors.
• Make sure that you fully back up your current Fabric Manager data on your management
server.
Migrating from Fabric Manager 5.4 or 5.5 on UNIX systems
Use the following procedure to migrate from Fabric Manager 5.4 or 5.5 software to DCFM 10.3.X on
a UNIX management server.
1. Insert the installation DVD into the DVD-ROM drive and open the following file.
<DVD_Drive>\DCFM\<UNIX_Platform>\install.bin
2. Click Next on the Introduction screen.
3. Read the agreement on the License Agreement screen, select I accept the terms of the
License Agreement and click Next.
4. Select the usual location for your system’s application files (for example, /opt/DCFM_10_3_X)
on the Select Install Folder screen and click Next.
Do not install to the root directory (for example, /).
5. Review the displayed installation summary on the Pre-Installation Summary screen and click
Install.