DCFM Installation, Migration, and Transition Guide - Supporting DCFM 10.3.x (53-1001360-01, October 2009)

24 DCFM Installation, Migration, and Transition Guide
53-1001360-01
Installing Professional Plus trial on UNIX systems
1
Installing Professional Plus trial on UNIX systems
1. Insert the installation DVD into the DVD-ROM drive and open the following file.
<DVD_Drive>\DCFM\<UNIX_Platform>\install.bin
2. Click Next on the Introduction screen.
3. Read the agreement on the License Agreement screen, select I accept the terms of the
License Agreement and click Next.
4. Select the usual location for your system’s application files (for example, /opt/DCFM10_3_X)
on the Select Install Folder screen and click Next.
Do not install to the root directory (for example, /).
5. Review the displayed installation summary on the Pre-Installation Summary screen and click
Install.
6. Make sure the Launch DCFM Configuration check box is selected (default) on the Installation
Complete screen, and click Done.
7. Click Next on the Welcome screen.
8. Select No on the Copy Data and Settings screen and then click Next.
To migrate data from a previous management application version, refer to Chapter 2,
“Migration”.
9. Click Next on the Server License screen.
10. Select Professional Plus on the Trial Editions screen and click Next.
11. Select Internal FTP Server or External FTP Server on the FTP Server screen and click Next.
If port 21 is busy, a message displays. Click OK to close the message and continue. Once the
Management application is configured make sure port 21 is free and restart the Server to start
the FTP service.
NOTE
If you use an FTP Server which is not configured on the same machine as DCFM, the Firmware
Repository feature will not be available.
FIGURE 10 FTP Server screen