DCFM Installation, Migration, and Transition Guide - Supporting DCFM 10.3.x (53-1001360-01, October 2009)

Table Of Contents
DCFM Installation, Migration, and Transition Guide 47
53-1001360-01
Enterprise trial pre-installation requirements on UNIX systems (headless)
1
17. Select the Start DCFM Client check box on the Start Server screen.
18. Click Finish.
After all of the selected services are started, the Log In dialog box displays.
19. Enter your user name and password.
The defaults are Administrator and password, respectively.
20. Click Login.
21. Click OK on the Login Banner.
Enterprise trial pre-installation requirements on UNIX systems
(headless)
An X Server display is required, even when performing a headless installation, to run the initial
configuration. Before you install DCFM, complete the following:
Make sure that an X Server is available for display and is configured to permit X Client
applications to display from the host on which they are installing the DCFM Server (typically,
this simply requires that the system console be present and running with a logged in user on
the X Server-based desktop session, such as KDE, GNOME, and so on).
The Display can be any host X Server (for example, DISPLAY can be set to display configuration
to another UNIX system that has an X based desktop).
Make sure that the DISPLAY environment variable is correctly defined in the shell with a valid
value (for example, to display to the local console, export DISPLAY=:0.0, or to display to a
remote system that has an X Server running, export DISPLAY=
<Remote_IP_Address>:0.0).
To display to a remote system you need to permit the remote display of the X Server by running
command xhost +IP, where IP is the IP address of the DCFM server host, on a local terminal
window of the X-based desktop of the remote system.
You may also need to consider a firewall that might block the display to the X Server which
listens by default on TCP port 6000 on the remote host.
To display to a remote system you need to permit the remote display of the X Server by running
command xhost +IP, where IP is the IP address of the DCFM server host from the X based
desktop of the remote system.
Make sure you test the DISPLAY definition by running the command xterm from the same shell
from which you run
install.bin. A new X terminal window to the destination X Server display
should open.