HP StorageWorks Fabric OS 6.2 administrator guide (5697-0016, May 2009)

120 Configuring advanced security features
fabric and not to pre-5.2.0 switches. Fabric OS 5.2.0 switches receive the distribution and will ignore
the FCS database.
FCS policy restrictions
The backup FCS switches normally cannot modify the policy. However, if the Primary FCS switch in the
policy list is not reachable, a backup FCS switch is allowed to modify the policy.
Once an FCS policy is configured and distributed across the fabric, only the Primary FCS switch can
perform certain operations. Operations that affect fabric-wide configuration are allowed only from the
Primary FCS switch. Backup and non-FCS switches cannot perform security, zoning, and AD operations
that affect the fabric configuration. The following error message is returned if a backup or non-FCS switch
tries to perform these operations.
Can only execute this command on the Primary FCS switch.
Operations that do not affect the fabric configuration, such as show or local switch commands, are
allowed on backup and non-FCS switches.
FCS enforcement applies only for user-initiated fabric-wide operations. Internal fabric data propagation
because of a fabric merge is not blocked. Consequently, a new switch that joins the FCS-enabled fabric
could still propagate the AD and zone database.
Table 27 shows the commands for switch operations for Primary FCS enforcement.
FCS enforcement does not apply to pre-5.3.0 switches and they will be able to initiate all operations.
Overview of FCS policy management
Whether your intention is to create new FCS policies or manage your current FCS policies, you must follow
certain steps to ensure that the domains throughout your fabric have the same policy.
NOTE: The local-switch WWN cannot be deleted from the FCS policy.
1. Set the pre-5.3.0 switches in the fabric to accept the FCS policy using the fddCfg --localaccept
or fddCfg
--localreject command.
2. Create the FCS policy using the secPolicyCreate command.
Table 27 Switch operations
Allowed on FCS switches Allowed on all switches
secPolicyAdd (Allowed on all switches for SCC
and DCC policies as long as it is not fabric-wide)
secPolicyShow
secPolicyCreate (Allowed on all switches for
SCC and DCC policies as long as it is not
fabric-wide)
fddCfg –-localaccept or fddCfg
--localreject
secPolicyDelete (Allowed on all switches for
SCC and DCC policies as long as its not
fabric-wide)
userconfig, Passwd, Passwdcfg (Fabric-wide
distribution is not allowed from a backup or
non-FCS switch.)
secPolicyRemove (Allowed on all switches for
SCC and DCC policies as long as its not
fabric-wide)
secPolicyActivate
fddCfg –-fabwideset secPolicySave
Any fabric-wide commands secPolicyAbort
All zoning commands except the show commands SNMP commands
All AD commands configupload
Any local-switch commands
Any AD command that does not affect fabric-wide
configuration