HP StorageWorks Fabric OS 6.2 administrator guide (5697-0016, May 2009)

Displaying the network interface settings

If an IP address has not been assigned to the network interface (Ethernet), you must connect to the Fabric

OS CLI using a console session on the serial port. For more information, see ”Console sessions using the

serial port” on page 31. Otherwise, connect using SSH.

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the ipAddrShow command.

ecp:admin> ipaddrshow

SWITCH

Ethernet IP Address: 10.1.2.3

Ethernet Subnetmask: 255.255.240.0

CP0

Ethernet IP Address: 10.1.2.3

Ethernet Subnetmask: 255.255.240.0

Host Name: ecp0

Gateway IP Address: 10.1.2.1

CP1

Ethernet IP Address: 10.1.2.4

Ethernet Subnetmask: 255.255.240.0

Host Name: ecp1

Gateway IP Address: 10.1.2.3

IPFC address for virtual fabric ID 123: 11.1.2.3/24

IPFC address for virtual fabric ID 45: 13.1.2.4/20

Slot 7

eth0: 11.1.2.4/24

Gateway: 11.1.2.1

Backplane IP address of CP0 : 10.0.0.5

Backplane IP address of CP1 : 10.0.0.6

IPv6 Autoconfiguration Enabled: Yes

Local IPv6 Addresses:

sw 0 stateless fd00:60:69bc:70:260:69ff:fe00:2/64 preferred

sw 0 stateless fec0:60:69bc:70:260:69ff:fe00:2/64 preferred

cp 0 stateless fd00:60:69bc:70:260:69ff:fe00:197/64 preferred

cp 0 stateless fec0:60:69bc:70:260:69ff:fe00:197/64 preferred

cp 1 stateless fd00:60:69bc:70:260:69ff:fe00:196/64 preferred

cp 1 stateless fec0:60:69bc:70:260:69ff:fe00:196/64 preferred

IPv6 Gateways:

cp 0 fe80:60:69bc:70::3

cp 0 fe80:60:69bc:70::2

cp 0 fe80:60:69bc:70::1

cp 1 fe80:60:69bc:70::3

If the Ethernet IP address, subnet mask, and gateway address are displayed, the network interface is

configured. Verify that the information is correct. If DHCP is enabled, the network interface information

was acquired from the DHCP server.

You can use either IPv4 or IPv6 with a classless inter-domain routing (CIDR) block notation (also known as

a network prefix length) to set up your IP addresses.