Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

272 Fabric OS Message Reference
53-1002448-01
FCR-1075
37
Recommended
Action
Keep the number of LSAN Zones to the lower limit of the two CPs or upgrade the remote CP.
Severity ERROR
FCR-1075
Message <timestamp>, [FCR-1075], <sequence-number>,, ERROR, <system-name>, Zone Name
configuration is larger than <Zone Name Limit> characters in the edge fabric
connected to port <port numer>.
Probable Cause Indicates that the zone name configuration size created in the connected fabric exceeds the
maximum supported by the FC Router. This size is equal to the total number of characters used by
all the zone names in the edge fabric zoning database.
The limit includes both logical storage area network (LSAN) and Non-LSAN zone names defined in
zoning name database of the edge fabric.
Recommended
Action
Limit the zone configuration size in the edge fabric connected to this port by either reducing
number of zones or changing the zone names to smaller names.
Severity ERROR
FCR-1076
Message <timestamp>, [FCR-1076], <sequence-number>,, INFO, <system-name>, Port <port
number> disabled, system only supports <maximum fds> front domains.
Probable Cause Indicates that the maximum number of supported front domains was exceeded. To enable the
specified port, disable any other operational front domain and then re-enable the port.
Recommended
Action
Make sure to remain within the maximum of supported front domains.
Severity INFO
FCR-1077
Message <timestamp>, [FCR-1077], <sequence-number>,, WARNING, <system-name>, Port <port
number> rejected fabric binding request/check from the M-Model switch; <Fabric
ID>.
Probable Cause Indicates that an M-Model edge switch attempted to either activate or check the fabric binding.
This port will be disabled if this event occurred during a check of fabric binding and not during
failure to activate fabric binding. The error is caused when the binding list details configured on the
M-Model switch does not match with the currently configured front port domain ID and WWN of the
EX_Port on which this operation was attempted.