Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 753
53-1002448-01
Chapter
115
ZONE System Messages
ZONE-1002
Message <timestamp>, [ZONE-1002], <sequence-number>,, WARNING, <system-name>, WWN
zoneTypeCheck or zoneGroupCheck warning(<warning string>) at port(<port number>).
Probable Cause Indicates that a zone filter or zone group check failure occurred. The frame filter logic reported a
failure when creating or adding the zone groups during port login (PLOGI) trap processing. This
message usually indicates problems when adding the content-addressable memory (CAM) entries
before the filter setup.
Recommended
Action
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Severity WARNING
ZONE-1003
Message <timestamp>, [ZONE-1003], <sequence-number>,, WARNING, <system-name>,
zone(<current zone>) contains (<domain id>, <port number>) which does not exist.
Probable Cause Indicates that the port zone member that is targeted for the local switch contains a nonexistent
port. The specified port number in the effective zoning configuration (displayed in the error
message) is out of range.
Recommended
Action
Edit the zone database and change the port number to a viable value in the effective configuration.
Severity WARNING
ZONE-1004
Message <timestamp>, [ZONE-1004], <sequence-number>,, INFO, <system-name>, port <port
number> (0x<port number (hex)>) enforcement changed to Session Based HARD Zoning.
Probable Cause Indicates that the zoning enforcement has changed to session-based hard zoning due to one of the
following conditions:
• The zone has a mix of WWN and domain, index (D,I) members.
• The Source Identifier (S_ID) list of the hardware-enforced zoning exceeded the S_ID limit.