Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 13
53-1002448-01
Commands for displaying and configuring the system message logs
1
bdClearTrap: YES
FE-MIB (yes, y, no, n): [yes]
SW-MIB (yes, y, no, n): [yes]
FA-MIB (yes, y, no, n): [yes]
FICON-MIB (yes, y, no, n): [yes]
HA-MIB (yes, y, no, n): [yes]
FCIP-MIB (yes, y, no, n): [yes]
ISCSI-MIB (yes, y, no, n): [yes]
IF-MIB (yes, y, no, n): [yes]
BD-MIB (yes, y, no, n): [yes]
SW-TRAP (yes, y, no, n): [yes]
swFault (yes, y, no, n): [yes]
swSensorScn (yes, y, no, n): [yes]
swFCPortScn (yes, y, no, n): [yes]
swEventTrap (yes, y, no, n): [yes]
DesiredSeverity: (0..4) [4] 3
swFabricWatchTrap (yes, y, no, n): [yes]
DesiredSeverity: (0..4) [0] 2
swTrackChangesTrap (yes, y, no, n): [yes]
swIPv6ChangeTrap (yes, y, no, n): [yes]
swPmgrEventTrap (yes, y, no, n): [yes]
[...]
3. Execute the snmpConfig --show mibCapability command to verify the severity level of
swEventTrap.
switch:admin> snmpconfig --show mibcapability
FE-MIB: YES
SW-MIB: YES
FA-MIB: YES
FICON-MIB: YES
HA-MIB: YES
FCIP-MIB: YES
ISCSI-MIB: YES
IF-MIB: YES
BD-MIB: YES
SW-TRAP: YES
swFault: YES
swSensorScn: YES
swFCPortScn: YES
swEventTrap: YES
DesiredSeverity:Informational
swFabricWatchTrap: YES
DesiredSeverity:Critical
swTrackChangesTrap: YES
swIPv6ChangeTrap: YES
swPmgrEventTrap: YES
swFabricReconfigTrap: YES
[...]
Commands for displaying and configuring the system message logs
Table 3 describes commands that you can use to view or configure the system message logs. Most
commands require the admin access level. For detailed information on required access levels and
commands, refer to the Fabric OS Command Reference.