Brocade Network Advisor Installation Guide v11.1x (53-1002320-01, May 2011)

10 of 47 Brocade Network Advisor Installation Guide
53-1002320-01
Management server and client ports
Table 4 lists the ports that need to be opened up in the firewall for Trial and Licensed Version.
24610 connector.bind.port – port 10 TCP Port to listen for requests on Server No
1 Port is not configurable (either in the switch or the Management server).
2 Every FTP session requires an additional port which is randomly picked. If the firewall is enabled then FTP operation (used for firmware
download, technical support, firmware import (from client-server) and so on.) will fail.
3 Ports configurable in the switch and the Management server. Port must be the same for all switches managed by the Management
server.
4 Ports used to launch the Web Tools application for Fabric OS switches from the Management client. This is applicable only when the
Fabric OS version is earlier than 6.1.1.
5 Port 80 is the default web server port number. If you set the web server port number to a port other than the default, you must open that
port in the firewall.
6 The Syslog listening port is configurable in the Management server. The switch always sends syslog messages to port 514. If you have
any other syslog daemon on the Management server machine already listening to 514, then the Management Server can be configured
to listen to a different port. You must manually configure relay in existing syslogd to forward the syslog messages to the Management
Server listening on the configured port.
7 The Management server tries to find a contiguous block of 13 ports from the starting port configured (for example, 24600); if any port in
this range is not available for the Management application, then you must provide a new starting port. Note that Port 1 to Port 12 in
“Ports” column of the table above are not separately configurable and those ports vary based on the starting port number configuration
(specified as Port 0 in the above table). The port numbers mentioned in the table above are the default ports (for example, when 24600
is selected as the starting port number).
TABLE 4 Trial and Licensed Version ports
Port Number Ports Transport Description Communication Path Open in Firewall
20
1
FTP Port (Control) TCP FTP Control port for internal
FTP server
Client–Server
Switch–Server
Yes
Yes
21
1, 2
FTP Port (Data) TCP FTP Data port for internal
FTP server
Client–Server
Switch–Server
Yes
Yes
22
1
SSH or Secure Telnet TCP Sectelnet port from server to
switch/client to switch
Server–Switch
Client–Switch
Yes
23
1
Telnet TCP Telnet port from server/client
to switch
Server–Switch
Client–Switch
Yes
25 SMTP Server port TCP SMTP Server port for E-mail
communication
Server–SMTP
Server
Yes
49 TACACS+ Authentication port TCP TACACS+ server port for
authentication if TACACS+ is
chosen as an external
authentication
Server–TACACS+
Server
Yes
80 jboss.web.http.port TCP Non-SSL HTTP/1.1 connector
port
Client–Server Yes
80
3, 4
Switch http TCP Switch non-SSL http port for
http and CAL communication
Server–Switch
Client–Switch
Yes
161
1
SNMP Port UDP Default SNMP port Server–Switch Yes
162
3
snmp.trap.port UDP Default SNMP trap port Switch–Server Yes
TABLE 3 Professional ports (Continued)
Port Number Ports Transport Description Communication Path Open in Firewall