Brocade Network Advisor Installation Guide v11.1x (53-1002320-01, May 2011)

Brocade Network Advisor Installation Guide 25 of 47
53-1002320-01
Trial configuration
d. Enter a port number in the Syslog Port # field (default is 514).
NOTE
If the default syslog port number is already in use, you will not receive any syslog messages from the device.
To find and stop the process currently running on the default syslog port number, refer to “Syslog
troubleshooting” on page 39.
e. Enter a port number in the SNMP Port # field (default is 162).
f. Click Next.
If you enter a syslog port number already in use, a message displays. Click No on the message to remain on
the Server Configuration screen and edit the syslog port number (return to step 7d). Click Yes to close the
message and continue with step 6.
If you enter a port number already in use, a warning displays next to the associated port number field. Edit
that port number and click Next.
8. Verify your configuration information on the Server Configuration Summary screen and click Next.
9. Select the Start Client check box, if necessary, on the Start Server screen and click Finish.
After all of the Network Advisor services are started, the Log In dialog box displays.
10. Enter your user name and password.
The defaults are Administrator and password, respectively.
11. Click Login.
12. Click OK on the Network Advisor Login Banner.
Trial configuration
Use Table 23 to help configure a trial package. If you have not installed the application, refer to “Installing the
application” on page 20. If you are migrating data, refer to the Network Advisor Migration Guide.
Configuring a trial package
1. Click Next on the Welcome screen.
2. Select No on the Copy Data and Settings screen and then click Next.
To migrate data from a previous version, refer to the Network Advisor Migration Guide.
3. Select one of the following options on the Package screen and click Next.
• SAN with SMI Agent
• SMI Agent only
If you selected SMI Agent only, refer to “SMI Agent only configuration” on page 35.
TABLE 23 Trial package configuration
Operating system Procedures
Windows or UNIX systems To configure SAN trial or full edition, complete the following procedures, as necessary:
• “Configuring a trial package” on page 25
• “Installing the ODBC driver on Windows systems” on page 40
• “Configuring an explicit server IP address” on page 41
• “Smart Card driver installation” on page 42 (UNIX only)