Brocade Network Advisor Installation Guide v11.1x (53-1002320-01, May 2011)

Brocade Network Advisor Installation Guide 35 of 47
53-1002320-01
SMI Agent only configuration
After all of the services (SLP and SMI Agent) are started, the configuration wizards closes. To make changes
to the SMI Agent configuration, you can re-launch the configuration wizard (Start > Programs > Network
Advisor 11.1.X > Configuration Wizard). You can access the SMIA Configuration Tool from the Server
Management Console (Start > Programs > Network Advisor 11.1.X > Server Management Console). For
information about the server management console, refer to the Brocade Network Advisor User Manual or
online help.
After all of the selected services are started, the Log In dialog box displays.
13. Enter your user name and password.
The defaults are Administrator and password, respectively.
14. Click Login.
15. Click OK on the Network Advisor Login Banner.
SMI Agent only configuration
Use Table 25 to help configure the SMI Agent only.
Configuring SMI Agent only
NOTE
If you choose to install only the SMI Agent, the configuration defaults to the SAN Enterprise package. When you open
the Network Advisor client, a License dialog displays, where you must enter a SAN Enterprise license key to use the
client. If you enter a SAN Professional Plus license key, you must re-install the application.
1. Click Next on the Welcome screen.
2. Select No on the Copy Data and Settings screen and then click Next.
3. Select SMI Agent only on the Package screen and click Next.
TABLE 25 SMI Agent only configuration
Operating system Procedures
Windows and UNIX systems To configure the SMI Agent only, complete the following sections:
• “Installing the application” on page 20
• “Configuring SMI Agent only” on page 35