HP IO Accelerator Driver and Management Software Version 2.2.2 Release Notes

Errata 18
3.
Stop any running Windows® services related to ioMemory VSL products (for example, the fio-agent
utility):
a. Open Device Manger.
b. Navigate to the Services menu.
c. Select Stop on these running services.
4. Reboot the system.
5. After the system has rebooted, navigate to the installation directory of the driver and remove any files
that were left over from the previous installation (at a minimum, any leftover .dll files). If you receive an
access denied error when attempting to remove these files, be sure you have Administrator
privileges.
6. Remove the fio.dll file from the Windows\System32 directory.
NOTE: If the fio.dll file does not exist in this directory, proceed to step 7.
7. You are now able to run the new installer without error. If you still encounter errors, contact HP Customer
Support (http://www.hp.com/support).
VMWare ESX-specific issues
The following issues apply only to systems running ESX operating systems.
ESXi not supported
There is a known limitation that ESXi is not yet supported.
The IO Accelerator VSL driver is unsigned
The driver is not signed until a future release of ESX.
HP IO Accelerator Management Tool-specific issues
The following issues apply specifically to the HP IO Accelerator Management Tool.
IO Accelerator Management Tool in Linux enables preallocate (for
swap support) in wrong file
The IO Accelerator Management Tool writes the preallocate_memory parameter to the
/etc/modprobe.d/fio-driver.conf file, but it should be writing the option to the
/etc/modprobe.d/iomemory-vsl.conf file. Preallocate is still enabled properly.