QLogic QConvergeConsole User Guide (SN0054669-00A, January 2011)

1–System Requirements
Software Requirements
1-2 SN0054669-00 A
The minimum hardware requirements for the server agent are as follows:
 Adapters. One or more of the QLogic adapters listed under “Supported
QLogic Adapters” on page 1-4.
The minimum requirements for a SAN environment are as follows:
 Storage. Fibre Channel or iSCSI devices, such as disks and RAID
subsystems. QConvergeConsole supports most Fibre Channel and iSCSI
devices. See the QLogic Storage Networking Interoperability Guide, which
you can download from the following QLogic Web page:
http://connect.qlogic.com/interopguide/info.asp
Software Requirements
The software requirements are as follows:
 Server on which your adapter is physically installed
 QLogic adapter drivers for your operating system.
 QLogic adapter management agents for your operating system.
 TCP/IP protocol for Windows remote management.
 Administrative privileges to perform management functions.
 Disable user access control to run the agent service (qlremote) on
Windows 2008.
 Apache Tomcat application server
 Apache Tomcat (if not already installed, installed using the
QConvergeConsole installer)
 QConvergeConsole
NOTE:
Tape devices are shown as part of the configuration, but are not fully
supported. Only persistent binding is supported.
NOTE:
Refer to the QLogic Web site for QLogic adapter drivers and agents:
http://driverdownloads.qlogic.com
.