Emulex OneCommand Manager Command Line Interface User Manual (P006980-01A Version 5.2, August 2011)

OneCommand Manager Command Line Interface User Manual Page 9
2. If the HBAnyware Security Configurator is installed, follow these steps:
a. Log on as ‘root’.
b. Change to the directory containing the tar file.
c. Extract the tar file using the tar -xvf command.
d. Change to the newly created directory.
e. Run the uninstall script with the ssc parameter specified. Type:
./uninstall ssc
3. Uninstall the HBAnyware utility and the Application Helper module:
a. Log on as ‘root’.
b. Change to the directory containing the tar file.
c. Extract the tar file using the tar -xvf command.
d. Change to the newly created directory.
e. Uninstall any previously installed versions. Type:
./uninstall
In Solaris
To uninstall the OneCommand Manager CLI on Solaris:
1. Log in as ‘root’.
1. Run /opt/ELXocm/scripts/uninstall.
Or
Run the uninstall script located in the installation tar file.
Or
Enter the command pkgrm ELXocmcore.
Upgrading the OneCommand Manager CLI to the OneCom-
mand Manager Application Enterprise Kit
Note: An upgrade can be performed only if the version of the OneCommand Manage
rapplication enterprise kit is the same or later than the OneCommand Manager CLI
version. You cannot upgrade a OneCommand Manager CLI with a previous version of
the OneCommand Manager application enterprise kit.
Note: When the OneCommand Vision Sensor software is installed on production
servers with Emulex adapters installed, the Sensor software may load and use some
of the software components included in the OneCommand Manager application or
HBAnyware utility software stacks. It is essential that the OneCommand Vision
Sensor software be stopped before performing any upgrades, or updates, to the
OneCommand Manager application or HBAnyware software stack components. For
information on stopping the Sensor, refer the OneCommand Vision user manual.