Emulex OneCommand Manager Command Line Interface User Manual (P006980-01A Version 5.2, August 2011)

OneCommand Manager Command Line Interface User Manual Page 73
RemoveHost
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd RemoveHost host_address
Description: This command removes a host from the hosts file use for TCP/IP management in the
OneCommand Manager application GUI. The host_address can be an IP address, using the IPv4 or
IPv6 format, or a host name.
Parameters:
host_address - Host to remove
Reset
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd Reset <WWPN>
Description: This command resets the adapter. An adapter reset can require several seconds to
complete, especially for remote devices. When the reset is completed, the system command prompt is
displayed.
Parameters:
WWPN - Adapter’s WWPN
SetCimCred
Supported by: VMware
Syntax:
hbacmd SetCimCred <username> <password> <namespace> <portnum>
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 73.
Note: Supported only for FC and FCoE ports. Not supported for NIC and iSCSI ports.
Note: For OneConnect FCoE ports, this command only resets the driver to update
changed driver parameters that require a driver reset. It does not cause a hardware
reset of the adapter port.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 73.
Note: Use this command to set only the CIM credentials. Once this is done,
subsequent hbacmd commands do not require you to specify the CIM credentials in
the command line.