Emulex OneCommand Manager Command Line Interface User Manual (P006980-01A Version 5.2, August 2011)

OneCommand Manager Command Line Interface User Manual Page 2
New Commands
The following new commands are supported in OneCommand Manager CLI:
• Diagnostic Commands
• CableNVP
• Micellaneous Commands
• AddHost and RemoveHost commands now support IPv6 address formats in addition to
IPv4 address formats
Installing the OneCommand Manager CLI
In Windows
There are two ways to install the OneCommand Manager CLI in Windows:
• Attended installation
• Unattended installation
Attended Installation in Windows
To install the OneCommand Manager CLI, run the installation.exe file for a core Windows driver kit that
does not include the OneCommand Manager GUI:
• elxocmcore-windows-<
arch>-<kit version>.exe
<
arch> is either x64 or x86.
<kit version> represents the complete version.
For example: elxocmcore-windows-x64-5.0.2.14-1.exe.
Unattended Installation in Windows
To install the OneCommand Manager CLI application in Windows:
1. From the Emulex website, download the x64 or x86 OneCommand Manager Core Kit installation
file to your system.
2. At the command prompt, set the optional switch to /q or /q2. The kit is activated with this optional
switch. The /q switch displays some progress reports. The /q2 switch does not display progress
reports.
For example:
elxocmcore-windows-x64-5.01.00.10-4.exe /q2
Note: For Itanium 64 systems install the x86 kit.