HP Unified Wired-WLAN Products OAA Command Reference HP 830 Unified Wired-WLAN PoE+ Switch Series HP 870 Unified Wired-WLAN Appliance HP 11900/10500/7500 20G Unified Wired-WLAN Module Part number: 5998-4795 Software version: 3507P22 (HP 830 PoE+ Switch Series) 2607P22 (HP 870 Appliance) 2507P22 (HP 11900/10500/7500 20G Module) Document version: 6W101-20140418
Legal and notice information © Copyright 2014 Hewlett-Packard Development Company, L.P. No part of this documentation may be reproduced or transmitted in any form or by any means without prior written consent of Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice.
Contents OAP module commands ·············································································································································· 1 oap connect ······························································································································································ 1 oap management-ip ················································································································································· 1
OAP module commands Support for OAP module commands depends on the device model. For more information, see About the Command References for HP Unified Wired-WLAN Products. oap connect Use oap connect to access the CLI of the OAP module from the device. Syntax oap connect slot slot-number Views User view Default command level 1: Monitor level Parameters slot slot-number: Specifies the number of the slot where an OAP system resides. Usage guidelines To return to the device's CLI, press Ctrl+K.
Parameters ip-address: Specifies the management IP address of the OAP module. This address must be configured on the OAP module. slot slot-number: Specifies the number of the slot where an OAP system resides. Usage guidelines To use NMS to manage an OAP module, you must first configure the management IP address of the OAP module. Examples # Configure the management IP address of the OAP module in slot 0 as 1.1.1.1 on HP 870 Unified Wired-WLAN Appliance. System-view [Sysname] oap management-ip 1.
Support and other resources Contacting HP For worldwide technical support information, see the HP support website: http://www.hp.
Conventions This section describes the conventions used in this documentation set. Command conventions Convention Description Boldface Bold text represents commands and keywords that you enter literally as shown. Italic Italic text represents arguments that you replace with actual values. [] Square brackets enclose syntax choices (keywords or arguments) that are optional. { x | y | ... } Braces enclose a set of required syntax choices separated by vertical bars, from which you select one.
Network topology icons Represents a generic network device, such as a router, switch, or firewall. Represents a routing-capable device, such as a router or Layer 3 switch. Represents a generic switch, such as a Layer 2 or Layer 3 switch, or a router that supports Layer 2 forwarding and other Layer 2 features. Represents an access controller, a unified wired-WLAN module, or the switching engine on a unified wired-WLAN switch. Represents an access point.
Index DOSW D oap reboot,2 Documents,3 S O Subscription service,3 oap connect,1 W oap management-ip,1 Websites,3 6
