HP Integrity and HP 9000 iLO MP Operations Guide, Fifth Edition

MODEM PRESENCE When the modem might not always be connected, set this
parameter to “not always connected.”
Example: A modem attached through a switch. In mode
“not always connected,” no dial-out functions are allowed:
DIAL-BACK is disabled, and PAGING is not possible.
The iLO MP mirrors the system console to the iLO MP local, remote/modem, and LAN ports.
One console output stream is reflected to all connected console users. If several different terminal
types are used simultaneously, some users might see unexpected results.
Command line usage and scripting:
CA [ -local ] [ -bit <n> ] [ -flow >software|hardware> ] ] [ -nc ]
-?
See also: SA
DATE: Display the current date
Command access level: Login access
DATE displays the current date, as best known to the iLO MP. The usual source for the date is
from the BMC, but if the BMC date is not available, the iLO MP realtime clock is used. The
realtime clock is used only when the iLO MP is first powered on or rebooted, until it can obtain
the correct date from the BMC.
Command line usage and scripting:
DATE [ -nc ]
-?
DC (Default Configuration): Reset all parameters to default configurations
Command access level: MP configuration access
DC sets all iLO MP all parameters back to their default values. The following parameters are
reset:
To restore specific configurations to their defaults use the following commands:
Remote Console Serial Port Modem configuration: CA -all DEFAULT
MP IP configuration : LC -all DEFAULT
Remote Access Configuration : SA -all DEFAULT
Command Interface configuration : IT -all DEFAULT
MP Security configuration : SO -all DEFAULT
MP Session configuration : IT -all DEFAULT
MP User configuration : UC -all DEFAULT
SNAP Configuration : SNMP -all DEFAULT
Use any of the following methods to reset passwords in the iLO MP:
• In the UC command, change individual users or reset all users to default values.
• Reset passwords by pressing the MP Reset button on the back panel of the server. After the
iLO MP reboots, the local console terminal displays a message for five seconds. Responding
to this message in time enables a local user to reset the passwords.
NOTE: All user information (logins, passwords, and so on) is erased when you use any of
the previous reset methods.
Command line usage and scripting:
DC [ -all default [ -nc ] ]
-?
DF: Display FRUID information
Command access level: login access
56 Using iLO