Manualshelf

HP Integrity and HP 9000 iLO MP Operations Guide, Fifth Edition

ManualsBrandsHP ManualsServerHP 9000 rp3440-4 Server
61626364656667686970
LS: LAN status
Command access level: Login access
LS displays all parameters and the current status of the iLO MP LAN connections. The LAN
parameters are not modified by this command.
Command line usage and scripting:
LS [ -nc ]
-?
See also: DNS, LC, SA
MR: Modem reset
Command access level: MP configuration access
MR makes the iLO MP send an at z command to the modem, which resets it. Any modem
connections are lost. You can view the initialization results by using the MS command.
Command line usage and scripting:
MR [ -nc ]
-?
See also: MS
MS: Modem status—display modem status
Command access level: Login access
MS displays the state of the modem lines connected to the remote or modem serial port. Update
the display by pressing Enter. The MS command displays the current state of the status signals
DCD, CTS, DSR, RI, and the last state of the control signals DTR, and RTS set by the firmware.
Command line usage and scripting:
MS [ -loop <n> ] [ -delay <n> ] [ -nc ]
-?
See also: MR, SA
PC: Power control—turn system power on and off
Command access level: Power control access
PC switches the system power on or off. A power cycle option is available that provides a
30-second delay between system power on and power off.
ON Turns the system power on. This command has no affect if the power
is already on.
OFF Turns the system power off. This command is equivalent to turning
the system power off at the front panel switch. There is no signal sent
to the OS to shut the software down before power is turned off. To
turn the system off gracefully, ensure that the OS is shut down before
running this command.
CYCLE Turns the system power off, then on. The delay between off and on
is 30 seconds.
Graceful Shutdown The BMC sends a signal to the OS to shut down prior to turning off
the system power.
IMPORTANT: This is equivalent to turning the system power off at the front panel switch. There
is no signal sent to the OS to bring the software down before power is turned off. To turn the
system off properly, ensure that the OS is in the proper shutdown state before issuing this
command. Use the proper OS commands or use the graceful shutdown option of the PC command.
Command line usage and scripting:
62 Using iLO