HP 9100C Digital Sender - (English) Administration Guide

38 Chapter 2 - Installing and configuring EN
Configure fast-track parameters at the control
panel
After you have physically installed the digital sender, you only need
to configure a few parameters at the control panel to begin using the
digital sender right away. After you have configured these “fast-track”
parameters, you will be able to send e-mail messages, use
e-mail addresses located on an LDAP server of your choosing, and
send documents to HP JetSend-enabled devices on your network.
The “fast-track” parameters consist of the following (see
“Configuration menu parameters” on page 80 for more detailed
explanations):
IP configuration (to specify how the digital sender is to receive
its TCP/IP configuration—manually or from a DHCP or BOOTP
server)
IP Address (of the digital sender)
IP Subnet Mask (if you use subnets)
IP Gateway (IP address of the gateway server used to send
packets off the local network)
E-mail Server Addr. (IP address of the SMTP-MIME e-mail
server)
E-mail Default From (default e-mail address for the FROM field
of e-mail messages from the digital sender)
Administrator Password (recommended—not required)
LDAP Server Address (IP address of the server that hosts the
LDAP server—not required)
LDAP Search Root (basepoint from which to start searches for
names on the LDAP server—required if you configure an LDAP
server address)
JetSend (either enabled or disabled—not required)