A3509A 16-bit Fast-Wide SCSI Adapter Quick Installation Guide

Table Of Contents

HP A3509A 16-Bit Fast-Wide SCSI Adapter

Installation Guide

All HP A3308A, A3511A, and A3511AZ Fibre Channel SCSI Multiplexers (MUX) have at least one factory-installed

16-bit Fast-Wide differential SCSI adapter in Slot 0. Its location and part number are shown below.

Figure 1

Up to three additional SCSI adapters, Product No. HP A3509A, can be installed in Slots 1, 2, and 3. Customers install

additional SCSI adapters in the following steps:

)&$GDSWHU

$ 0ESVVKRUWZDYH

2SWLFDO3RUW3URWHFWRU



6&6,$GDSWHU

$

0HPRU\&DUG

$

6&6,

7HUPLQDWRU

$

3RZHU6XSSO\



0RWKHUERDUG

$

PAGE 1
HP A3509A 16-Bit Fast-Wide SCSI Adapter Installation Guide All HP A3308A, A3511A, and A3511AZ Fibre Channel SCSI Multiplexers (MUX) have at least one factory-installed 16-bit Fast-Wide differential SCSI adapter in Slot 0. Its location and part number are shown below.
PAGE 2
Step 3: Remove the cover and bezel. Step 5: Slide the cover off and remove the bezel with an upward motion as shown in Figures 4 and 5. Insert and seat the new adapter. Grasp the top of the adapter card and align the tabs with any available SCSI slot. Gently push the card in the slot, using a forward and backward motion. See Figure 7. Figure 4 Figure 7 Tighten the two top screws to secure the card. Step 6: Replace the cover. Replace the cover as shown in Figure 8. Attach the cables and power cord.