HP A3716A DDS-3 Autoloader User's Manual - 3716-96001

Installing Your Autoloader
Configuring Software on Series 800 HP-PB (NIO) Systems Running HP-UX 10.01 or Later
2-9
Configuring Software on Series 800 HP-PB (NIO)
Systems Running HP-UX 10.01 or Later
Checking the Revision of the Tape Driver
1 Verify the tape driver revision is equal to or later than the original version
shown in the table that follows:
what /stand/vmunix | grep tape14.c
You should see something like this:
tape14.c $Date: 96/05/23 14:44:31 $ $Revision: 1.10.89.8 $ PATCH_10.10 (PHKL_7568)
n
If you have the original or later tape driver, continue with Configuring the
Pass-Through Driver below.
n If you do not have the correct driver, go on to step 2 to install the patch.
2 Save old versions of the library and boot kernel:
cd /etc/conf/lib
cp libhp-ux.a libhp-ux.aOLD
cp /hp-ux /hp-uxOLD
3 Copy the patch into the /tmp directory. Change to the /tmp directory and
unshar the patch:
cd /tmp
sh PHKL_8754
Note This example is for HP-UX 10.10. If you have HP-UX 10.01, use PHKL_8752 or
later. If you are using HP-UX 10.20, use PHKL_8756 or later.
4 Follow the instructions in the patch text file to install the patch. This patch will
cause the system to reboot.
5 After the system reboots, perform Step 1 again to verify the patch installation.
Determine your HP-UX revision:
uname -r
For your HP-UX revision, determine the original
revision of the tape driver from the table and verify
that the revision of the tape driver on your system
is equal to or later than the original revision.
HP-PB (NIO)
Tape Driver
Original
Revision
Original
Patch
Latest
Patch
HP-UX 10.01 1.8.71.21 PHKL_8869 PHKL_8752
HP-UX 10.10 1.10.89.8 PHKL_7568 PHKL_8754
HP-UX 10.20 1.15.98.4 PHKL_8118 PHKL_8756