HP A3716A DDS-3 Autoloader User's Manual - 3716-96001

Installing Your Autoloader
Configuring Software on Series 800 HP-PB (NIO) Systems Running HP-UX 9.04
2-14
Configuring Software on Series 800 HP-PB (NIO)
Systems Running HP-UX 9.04
Checking the Revision of the Tape Driver
1 Log in to the target system as root.
2 Verify the correct driver is in the kernel:
what /hp-ux | grep tape14.c
If it is there, you should see:
tape14.c $Date: 96/06/04 11:25:36 $ $Revision: 1.8.73.19 $ PATCH_9.04 (PHKL_7643)
or above
n If this is the case, go to Checking the Revision of the Pass-Through Driver
below.
n If the driver is not there, continue with step 3 to install the patch.
3 Save old versions of the library and boot kernel (in case you need to restore the
system to its original state):
cd /etc/conf/lib
cp libhp-ux.a libhp-ux.aOLD
cp /hp-ux /hp-uxOLD
4 Copy the patch PHKL_7643 or above into the /tmp directory. Change to the
/tmp directory and unshar the patch:
cd /tmp
sh PHKL_7643
5 The following procedure takes you through installing the tape driver patch.
Installing the patch will cause the system to reboot.
a Back up your system before installing the patch.
b Copy the patch to your /tmp directory and unshar it:
cd /tmp
cp patch_source/PHKL_7643
sh PHKL_7643
c
Become root and run update:
/etc/update
d
Use the cursor keys to select Change Source or Destination -> and
press [Return].
e Select From Tape Device to Local System ... in the Change
window and change Source: /dev/rmt/0m
to Source: /tmp/PHKL_7643.updt.