HP A3716A DDS-3 Autoloader User's Manual - 3716-96001

Installing Your Autoloader
Configuring Software on Series 800 HP-PB (NIO) Systems Running HP-UX 9.04
2-15
f Press f4 Done.
g Follow the standard directions for update.
Update removes the original software to /system/PHKL_7643/orig.
Keep this file to recover from any potential problems. You should move the
.text file to /system/PHKL_7643 for future reference.
6 After the system reboots, repeat step 2 to verify that you have installed the
patch correctly.
Checking the Revision of the Pass-Through Driver
Check the revision of the pass-through driver as follows:
what /etc/conf/lib/libspt.a
n
If the revision is scsi_pt.c $Revision: 2.1.1.2 $ $Date: 95/
03/24 14:50:24 $ PATCH_9.04 (PHKL_5405) or later, the correct
patch is installed. Go to Configuring the Pass-Through Driver below.
n If the revision is anything else or the file does not exist, you need to install
the patch. Go to Installing the Patch for the Pass-Through Driver below.
Installing the Patch for the Pass-Through Driver
1 Log in to the target system as root.
2 Save old versions of the library and boot kernel (in case you need to restore the
system to its original state):
cd /etc/conf/lib
cp libhp-ux.a libhp-ux.aORIG
cp /hp-ux /hp-uxORIG
3 Copy the patch PHKL_5405 into the /tmp directory. Change to the
/tmp directory and unshar the patch:
cd /tmp
sh PHKL_5405
4 Follow the instructions in the patch text file. The system does not reboot
automatically; you must reboot it for the changes to take effect.