HP A3716A DDS-3 Autoloader User's Manual - 3716-96001

Installing Your Autoloader
Configuring Software on Series 900 Systems Running MPE/iX Version 5.5 Power Patch 1 or Later
2-20
Configuring Software on Series 900 Systems Running
MPE/iX Version 5.5 Power Patch 1 or Later
Configuring Drivers Using SAM
To select the correct driver, proceed as follows.
While in terminal version mode:
1 Run SAM.
2 Select Kernel Config.
3 Select Drivers.
4 Scroll to find schgr.
5 Check the current state:
n in = OK. The driver is correctly configured.
n out = Modification is needed.
If the current state is out:
1 Go to menu bar Actions.
2 Select Add Drivers to Kernel. Press [Return].
The Pending State changes to in.
3 Scroll to find sctl.
4 Check the current state:
n in = OK. The driver is correctly configured, but you need to create a new
kernel. Go to Creating a New Kernel below.
n out = Modification is needed.
If the current state is out:
1 Go to menu bar Actions.
2 Select Add Drivers to Kernel. Press [Return].
The Pending State changes to in.
3 You now need to create a new kernel. Go to Creating a New Kernel below.
Creating a New Kernel
1 Go to menu bar Actions.