HP A3716A DDS-3 Autoloader User's Manual - 3716-96001

Installing Your Autoloader
Configuring Software on Series 900 Systems Running MPE/iX Version 5.5 Power Patch 1 or Later
2-22
c Save the configuration:
io>HOLD
d
Exit the IO configurator:
io>EXIT
sysgen>
e
Save the changes in the permanent file:
sysgen>KEEP
f
Save the changes made in the IO configurator to the default configuration
group. Respond with Y when SYSGEN asks whether you want to overwrite
this group.
Create a System Load Tape (SLT)
This procedure is optional, but recommended.
1 Mount a write-enabled tape on the system tape drive (DAT or ½-inch tape).
Ensure the tape drive is online.
2 Generate a customized SLT that includes the new configuration by entering the
TAPE command:
sysgen>TAPE
3 Reply to the tape request.
The system responds when it has finished generating the SLT by displaying the
following message:
**Boot tape is successfully built**
4 Exit SYSGEN:
sysgen>EXIT
Reboot with the New Configuration
1 Shut down the system.
2 Reboot the system, using START NORECOVERY.
Verifying the Installation of the Autoloader
Follow these steps to verify the installation:
1 Turn off the autoloaders power.
2 Turn on the autoloaders power and watch the front panel display.