HP A3716A DDS-3 Autoloader User's Manual - 3716-96001
Installing Your Autoloader
What Next?
2-23
Various messages showing the model number and firmware revision should
briefly appear, then the autoloaders self-test starts. All three front panel lights
flash and the message Self Test shows.
n At the end, if the test is successful, the pattern of lights and the message
displayed depend on whether a magazine was in the autoloader and whether
a cartridge was loaded in the drive mechanism.
For example, if no magazine is in the autoloader, no lights should show and
the message Insert Mag should be displayed.
n If the self-test fails, the Operator Attention Required (bottom) light changes
to steady amber and the other lights go off. See Chapter 9,
Troubleshooting, for details of what to do.
For any other messages, if they are not self-explanatory, refer to Chapter 4.
What Next?
Make a note inside the front cover of this guide of the following details so you
can easily find them in the future:
n The serial number of the autoloader
n The date on which the autoloader was purchased or received
n The SCSI ID
n The autoloader option switch value (default is 6)
You are now ready to begin using your autoloader. See Chapter 3 for details.