HP A3716A DDS-3 Autoloader User's Manual - 3716-96001

Radio Frequency Interference
Statement
(Federal Communications
Commission), USA only
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
manual, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, you are encouraged to try to correct the
interference by one or more of the following
measures:
n Reorient or relocate the receiving antenna.
n Increase the separation between the
equipment and the receiver.
n Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
n Consult your dealer or an experienced
radio/TV technician for help.
Note that if you change or modify the
equipment in a way that is not expressly
approved by Hewlett-Packard, any
assurances of safety or performance can no
longer be held to apply, and could result in
violation of Part 15 of the FCC Rules.
Interference
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference (2) this device must
accept any interference received including
interference that may cause undesired
operations.
WARNING: Only the double-shielded data
cable supplied by the manufacturer should be
used with external tape drives. Other types of
cables could void the manufacturer's
warranty and violate FCC rules and
regulations.
Notice for Canada
This digital apparatus does not exceed the
Class B limits for radio noise emissions from
digital apparatus as set out in the radio
interference regulations of the Canadian
Department of Communications.
Le présent appareil numérique n'émet pas de
bruits radioélectriques dépassant les limites
applicables aux appareils numériques de
Classe B prescrites dans le règlement sur le
brouillage radioélectrique édicté par le
Ministère des Communications du Canada.
Power Supply Outlet Requirements
For pluggable equipment the socket outlet
shall be installed near the equipment and shall
be easily accessible.
General Approval (NS/G/1234/J/
100003)
This Hewlett-Packard tape drive meets the
General Approval NS/G/1234/J/100003
requirements.
Herstellerbescheinigung
Diese Information steht im Zusammenhang
mit den Anforderungender Maschinenl
information sverordnung vom 18 Januar 1991.
Schalldruckpegel Lp <70 dB(A)
n am arbeitsplatz
n normaler betrieb
nach ISO 7779: EN 27779 (Typpr fung)
[This statement is provided to comply with
the requirements of the German Sound
Emission Directive, from 18 January 1991.
Sound pressure Lp <70 dB(A)
n at operator position
n normal operation
according to ISO 7779: EN 27779 (type
test)]