HP StorageWorks Fabric Manager 5.x Administrator Guide (AA-RUQSF-TE, September 2005)

Fabric Manager 5.x administrator guide 111
• Only when changes are detected
• Every time the check is run
17. Edit or enter the e-mail addresses; the minimum is one address. Separate multiple e-mail addresses with
commas.
18.Optional: Click Test to send a test message to the e-mail addresses specified.
19. Optional: Click Send alert when changes occur if you want alerts to be triggered for changes to this
change management profile.
20.Select an alert level for the change management alerts (info, warning, or critical).
21.Click Next.
A confirmation is displayed, indicating the selected settings for the cloned change management profile.
22.Verify the settings and then click Finish.
Fabric Manager saves the cloned change management profile information to the database.
23.To view the cloned change management profile, select Tools > Change Management > Manage
Profiles.
The Change Management Profiles dialog box opens (see Figure 58). Any existing profiles are
displayed in the dialog box.
Figure 58 Change management profiles (cloned entry)
NOTE: Figure 58 shows a change management profile and its clone. Since the Profile Name, Areas
(Parameters), Schedule, Fabrics, and Notification are identical, the only differences are the Profile IDs and
the Creation Times.
Editing a profile
To edit a change management profile:
1. Select Tools > Change Management > Manage Profiles.
The Change Management Profiles dialog box opens (see Figure 53 on page 107). Any existing
profiles are displayed in the dialog box.
2. Select the profile you want to edit and click Edit Profile.
The change management wizard opens.
3. Read the introduction and then click Next.
The Select Snapshot Items dialog box opens (see Figure 54 on page 107).
NOTE: You cannot change the snapshot items that are being monitored. To monitor a different set of
snapshot items, you must create a new profile.
4. The name of the change management profile you selected in step 2 is in the Please input profile name
dialog box. If you want to edit a different profile, you must exit the change management wizard and
select it.
5. Click Next.