HP StorageWorks Fabric OS 5.X Administrator Guide (AA-RVHWB-TE, September 2005)

210 Administering advanced performance monitoring
The command format is:
perfmonitorclear --class monitor_class [slotnumber/]portnumber [monitorId]
NOTE: In Fabric OS 3.1.0 and 4.1.0 (or later) the portStatsClear command clears AL_PA-based
CRC error counters for all the ports in the same group.
The following example clears statistics counters for an EE monitor:
The following examples clears statistics counters for a filter-based monitor:
The following example clears statistics counters for an ISL monitor:
where:
monitor_class Specifies the monitor class, which can be one of EE, FLT (filter-based), or
ISL. The --class monitor_class operand is required.
slotnumber Specifies the slot number for a Core Switch 2/64, SAN Director 2/128, or
4/256 SAN Director. For all other switches, this operand is not required. The
slot number must be followed by a slash ( / ) and the port number, so that
each port is represented by both slot number (1 through 4 or 7 through 10)
and port number (0 through 15).
The HP StorageWorks director has a total of 10 slots. Slot numbers 5 and 6
are CP blades; slots 1 through 4 and 7 through 10 are port blades. For
16-port blades, there are 16 ports, counted from the bottom, numbered 0 to
15. For 32-port blades, there are 32 ports numbered 0 to 31.
portnumber Specifies a port number. Valid values for port number vary, depending on the
switch type. This operand is required.
monitorId Specifies the monitor number to clear. Monitor numbers are defined when you
create the monitor on a port. This operand is optional. If not specified, all
monitor counters on the port are cleared. This operand does not apply to ISL
monitors.
switch:admin> perfMonitorClear --class EE 1/2 5
End-to-End monitor number 5 counters are cleared
switch:admin> perfMonitorClear --class EE 1/2
This will clear ALL EE monitors' counters on port 2, continue?
(yes, y, no, n): [no] y
switch:admin> perfMonitorClear --class FLT 1/2 4
Filter-based monitor number 4 counters are cleared
switch:admin> perfMonitorClear --class FLT 1/2
This will clear ALL filter-based monitors' counters on port 2, continue?
(yes, y, no, y): [no] y
switch:admin> perfMonitorClear --class ISL 1
This will clear ISL monitor on port 1, continue? (yes, y, no, n): [no] y